mighty little parts
& lots of options
Pound for pound, an ant is mightier than an elephant! Likewise, shelf to shelf, it may be that Popco’s small sign holders are as mighty as any merchandising hardware.
Snap our mighty little parts into your grocery shelves and install your signs easily. Position signs as you’d like — above the shelf deck, below the shelf deck, at a right-angle position — our little parts will do it all.
.
pinch, pierce & control position
Our CFH-1T sign holder (shown here), snaps into 1-1/4″ front-channels of standard shelves. It holds signs by pinching closed, and piercing sign stock with a small tab that locks into a corresponding hole. Then, the sign holder slides back and forth in the channel so that you can position your sign as needed.
A similar product, our CMH-2T sign holder (not shown), works in the same way but holds signs flush to the shelf rather than at a right angle. This is called a mirror position.
Both of these sign holders are perfect for one-time-use signs, when fast installation is a must. When a promotion is over, discard the old sign and reuse the holders with your next sign.
.
flush, or right angle,
you can do it all
Our SEC-1T sign holder, also snaps into 1-1/4″ store shelves. With this sign holder, you can mount signs either flush to a shelf (as shown), or at a right angle to the shelf.
Flip the SEC-1T upside down in the shelf channel, and you can mount a sign in a flush position that rises above the shelf deck. Also, with the SEC-1T, piercing sign stock is not required — important, if you’re reusing your signs.
Piercing style or non-piercing — flush mount or right angle, no matter what your approach is to placing signs in store shelf channels, Popco has you covered for small sign hardware.
made in USA.
.
